Field genius generic gps how to#
Field genius generic gps upgrade#

The setup has been completed successfully. Step 21 - Once connected the Map Screen will open and you should be receiving corrections. StepР’В 25 - Select a desired Mountpoint from the Sourcetable. StepР’В 24 - You will be prompted to choose Request Sourcetable.

Field genius generic gps upgrade#

Step 22 - Enter the Ntrip Settings for your Corrections Service. Upgrade from FieldGenius Standard to FieldGenius Premium 700 FieldGenius Hardware Bundles MicroSurvey DC5 with FieldGenius Standard Built-in GPS, 3MP camera, 624MHz CPU, 640x480 screen, 256MB RAM/storage up to 8GB, WiFi, Bluetooth, mic & speaker, USB, charger, 3000mAh battery, Windows Mobile 6. Set the Link Device to Data Collector Internet then choose Setup. Step 21 - The Link Configure menu will open. Step 20 - You should now see your instrument in the list. Pick on Bluetooth Device List to search for the GS16 / GS18 Step 17 - Pick Model and Communication and modifyР’В the settings to match below. Step 16 - Select the newly created Profile and choose Edit. Choose GNSS Rover > Add, toР’В create a profile for the GS18. Step 15 - After opening or starting a new project you will enter the Instrument Selection menu. FieldGenius 10.0 was used in this example. Step 13 - Select Use the following IP addresses and enter the IP address 192.168.253.1, and 255.255.255.0 under the Subnet mask. Step 12 - Select the Internet Protocol Version 4 (TCP/IPv4) then pick Properties.

Step 10 - Under active networks choose Bluetooth Network Connection. Step 9 - Open the Windows Control Panel (Can be found from the Window Start Menu or searching in the Device and Printers window in the previous step). Step 8 - A small window should display Connection successful. Tap to select and long hold on the device to bring up more options and choose Connect using > Ad hoc network. Step 7 - In the Devices and Printers window find the GS16 / GS18 Bluetooth Device (matching the name in Step 2). You can also open this Window from the Control Panel

Step 6 -Р’В In the Settings window choose Connected Devices from the options on the left, then pick Devices and Printers. Step 5 - Go back into your Bluetooth settings and check in the list that the GS16 / GS18 is paired Step 4 - Find and Select the Instrument in the list to connect and enter a Pin if necessary Step 2 - Select Add BlueTooth or other device Step 1 -Р’В SelectР’В the Windows Bluetooth Icon in the Task Tray. If the SIM card is installed into the GNSS reciever this method is not required. Note, this only applies if data collector internet (SIM card in the data collector) is being used to receive the corrections from the corrections service.

Field genius generic gps how to#

This guide explains how to establish a PAN connection using Windows 10 and FieldGeniusР’В 10 installed on a Getac tablet.

Posted by How Li on 17 January 2019 10:34 AMР”Р„ PAN (Personal Area Network) connection is used when connecting connecting the tablet version FieldGeniusР’В to a Leica GS16 / GS18 GPS.